Beginner
(if you are a beginner start here)

Experienced
(if you're experienced you can start here)

  1. Begin / Partslist
  2. Open XBOX
  3. Remove DVD drive and HD
  4. Unplug DVD drive and HD
  5. Unscrew motherboard

6. PIN header
7. Place a box
8. Soldering LPC and HDD/D0/LAN
9. Solder alternate 5V
10. Place chip
11. Pop off the front panel
12. Place the front switch
13. Final testrun and FLASH
<< Previous

  1. When you have removed the controller ports you can push the wire through.
  2. Push the wire trough a hole of your choice depending on where you place the switch. Pop the control panel back on.
  3. Plug in the cables
Next >>